So where is his pivot hole? I can't see one.
But that's besides the point, all indications are the "fuck you nubbins" piece was done using a cnc router.
The letters are flawless, along with the middle finger, and using a palm router you aren't gonna do that. Besides it makes no sense to do this kind of work by hand if you have access to cnc equipment, (which has been pretty much established at this point).
What remains is what it appears to be some guy exploiting his fablab membership to sell make believe handicraft works.
Pivot hole? Are you really that inept?
There are about a dozen ways to do the same thing when you cannot leave a hole behind. My personal favorite is by gluing a pin to the center with some wood glue. Takes about 4 hours to dry, and once the circles are done, you can knock it off with a hammer, and 5 seconds with a power sander will remove the glue marks.
You guys are seriously pathetic and way far out on a very shaky limb with all this shit.
The letters are flawless? No shit Sherlock, how hard is it to trace over a line? https://www.youtube.com/watch?v=BNcojZRQK7wTakes me 10 seconds on youtube to make you look like an idiot. How much more time to do you want to invest on sealing your fate?
It is better to be thought an idiot and remain silent than to open your mouth and remove all doubts. You and your MOB are going down in a ball of smoke and flames, might want to think about your actions for a minute before its too late and you lose all credibility you ever had in this place.
The Finger has lines in it which get thinner towards the ends. It's easy to accomplish that with a cnc router if the depth of the toolhead becomes more shallow towards the end of the line.
Using a hand router you are milling at constant depth.
I don't know much about wood handiworks but enough about cnc machining to recognize the products.