Call me worried but, I think I have found a setting that gets me a decent hash rate with temps below 60c. 300 with the current set up that I have will yield 59 and 57 degrees on the blades but within the first hour or so I get 1 hardware error and over the course of a day and a half (36hours) I have 12 hardware errors. Now, I am powering this miner with a high quality 80 gold 650watt power supply.

first of all, are 12 hardware errors over the course of 36 hours ok for the miner? does that seem a bit high? I suppose the cooler I get the less likely the hardware errors will be produced. I am getting two new noctua nf-f12 fans, one at 3000rpm (push) and one at 2000rpm (pull) to replace my current setup as the wife has finally said the miner it too loud and producing too much heat.

I am asking about hardware errors again because I noticed that when I first set the miner to 300 it performed at just over 1Th/s and now it is working at just under 1Th/s. Do hardware errors effect hash rate?