I read back a few pages looking for information about changing the fans on the S5's but was unable to find any information so I am starting the discussion over.
I received my 2 S5's yesterday and my parents promptly said "no" to the noise going on in the backroom from them. So now I need to replace the fans and my thinking was just to put 2 of them on either end like the S3 and call it good. I noticed on the controller for the S5, there are 2 4 pin slots so I figure this should be fine, but wanted to double check. I am thinking of running out and getting these today...
http://www.microcenter.com/product/423765/Air_Series_AF120_LED_Red_Quiet_Edition_Twin_Packand putting one on either end of each S5, but they are 3 pin connectors, should that be fine or should I find ones with 4 pin connectors (I thought 3 pin can plug into 4 pin slots?) Also the airflow is 52.19 CFM, should that be sufficient to cool an S5?
Thanks in advance, I appreciate all feedback
They should run fine with two of those fans using the 3 pin connector, but you won't have speed control. Depending on your ambient you might have to throttle down the speed quite a bit to keep the miner cool.