Connect 1 hashing PCB at a time to the control PCB and you should be able to pin point it to the troubled Hashing PCB.
Then you can try reapply thermo paste and see if it will resolve the case. If not and if it is still within the 90-day warranty, you can send it back to Denver or EU area service center or to the Factory in China and the replacement be send to you
China: +86 18511636219
US or EU techs you can reach them at +1-844-248-6246 x2
hi
i got problem with one unit.
one of boards is dropping after few hours of hashing (it hashes ~800GH/sec after some time)
only power off and on resolving issue
is there any other solution to fix this ?
i use miner at stock settings.
it is powered by 1300W platinum psu, tested others psu too, same issue
thanks
I have one that does this aswell. I have tried new firmware. Nothing I did seems to stop it after a few hours going down. I think it's one of my boards a this point.
I wonder if I could find the blade and redo thermal paste on it would help. But I have been afraid I will lose entire board if I happen to be wrong.