hi
i got problem with one unit.
one of boards is dropping after few hours of hashing (it hashes ~800GH/sec after some time)
only power off and on resolving issue
is there any other solution to fix this ?
i use miner at stock settings.
it is powered by 1300W platinum psu, tested others psu too, same issue
thanks
I have one that does this aswell. I have tried new firmware. Nothing I did seems to stop it after a few hours going down. I think it's one of my boards a this point.
I wonder if I could find the blade and redo thermal paste on it would help. But I have been afraid I will lose entire board if I happen to be wrong.
I attempted a check of the thermal paste. Tried to do this without cutting the cooling connection but instead twisting. Didn't work. I gave up and let it be. Those screw pairs on the S3's and S3+'s are only half used on each side, one screw per pair. Probably thru hole and the other board on the far side using the other screw. Easy to strip one of those and since not a pair it gets difficult. Unless you plan to go hole hog and rip it apart ....