Re: ◀ PrimeChain | Verify Prime Numbers | HUGE GIVEAWAY ON SUNDAY FOR MULTIPOOL ▶
@IGS
Noticed you removed your out of town post that you'd be keeping an eye on the thread.
Anyway, the previous install it ran fine for a while. Re DL'd the client from the main post here.
On a brand new install with nothing done but MBAM, MS Security Ess., and BTC, DOGE, LTC & GRID clients.
It's doing it again but with this "new" little window.
Noticed you removed your out of town post that you'd be keeping an eye on the thread.
Anyway, the previous install it ran fine for a while. Re DL'd the client from the main post here.
On a brand new install with nothing done but MBAM, MS Security Ess., and BTC, DOGE, LTC & GRID clients.
It's doing it again but with this "new" little window.
Try this: Open and Run your command prompt as administrator (Your PC's cmd.exe NOT the wallet console)
At the prompt type: BCDedit.exe /set increaseUserVA 2800
Hit: enter
Prompt should read: "The operation completed successfully."
Restart your machine.
The error should be fixed.
Before the fresh os, it did the "stop" thing. The cc++ thing started after the clean os install.
Did you try it? It just releases more memory for your cache....Your Boot Configuration Data...too much to get into...just try it...you can always reset back to default.
So how do I default bcd ?
I have a feeling your cpu is overheating or you have a bad ram stick. I meant hardware, not software
But ya, no heat / ram issues to speak of as I can bog down everything and not miss a beat but soon as I load PRIME, it might run for a few mins then BAM... dies.
@cjmoles: So how do I default bcd ?