Quote from: cignus76 on February 24, 2016, 06:03:33 AM

Okay so I tried to get the other blade up and running but it powered off my PSU after a couple of seconds, from what I've been reading that's because it can't support the draw that the S1 is trying to draw correct?
But it's also pretty late so I may have just configured something incorrectly.

I might put the pencil mod back on the other side and look into it just so I can get both blades up and running on one PSU.

Thanks again!

Now that you,ve removed it, you're gonna have to grab a multi meter and make it even on both sides. Or you'll get one board not being run at the right timeout/freq. And its possible, the load can do 400-500W, so i'd need to know what the PSU is.

I think the stock numbers are 180 GH/s for close to 400Watts. Undervolted you can get 140GH/s for 175Watts. Hence even people with free electricity run them undervolted.