Ninjastic
PostEdited versionsQuotes to this post
Post
Topic
Board Hardware
Re: GekkoScience Compac BM1384 Stickminer Official Support Thread
by
hurricandave
on 27/04/2016, 15:41:53 UTC
Quote from: drew_ii on April 27, 2016, 03:20:35 PM
Quote from: drew_ii on April 25, 2016, 09:08:19 PM
Quote from: zOU on April 25, 2016, 07:45:52 PM
Have you tried:

https://www.google.com/search?q=usb+3+wiring

lmgtfy eh? hehe yes i felt about as dumb when i read the reply - touche'.  My concern at this point would be the twin black thick wires as compared to the singular thinner power lead.  I can MM the +5 and Ground pins with minimal difficulty.

<--- rightfully a noob!

Frankenhub....



IS ALIVE!



Use the BBCode for Message Boards and Forums. The difference is the small letters img at the start the address includes i. before imgur  and it adds .jpg to the end which is what your picture posts have been missing.



One of these days the damned pictures will post gosh durnit - Haven't hooked her up to my Pi yet, but the +5VDC has been cut on the inbound line, and is only powered by the soldered leads.  Continuity testing confirms that all joints are isolated and continuous with original +5VDC input solder point, and no continuity between any other non-power solder joints, there are no bridges.