Ninjastic
PostEdited versionsQuotes to this post
Post
Topic
Board Pools
Re: [35+PH] Kano CKPool kano.is 0.9% PPLNS US,DE,SG,DK,JP,FR
by
clgrissom3
on 21/06/2016, 21:57:36 UTC
Quote from: clgrissom3 on June 20, 2016, 11:04:52 PM
Quote from: philipma1957 on June 20, 2016, 10:23:02 PM
Quote from: clgrissom3 on June 20, 2016, 09:32:24 PM
Quote from: citricut on June 20, 2016, 05:18:40 PM
Quote from: philipma1957 on June 20, 2016, 11:15:38 AM
my batch 2 s-9's are shipped.  so the solar array will go from 25th to 50 th   .  I am hoping the new fans ordered will help to keep the gear a bit cooler.

Mine too  Cheesy

Can't wait to plug them to kano.is

My S9 Batch 3 is up and running on kano.is...the speed and HW errors of each board were looking good and holding right at 12.87 THs (13THs on the pool) for about 45 minutes.  The temps on each board were about 57, 87 and there were only about 3 errors on each board.  Then the 3rd board dropped to zero and eventually dropped out of the picture.  Now I have about 8.3THs total running with the first 2 boards.  Soft reboots have not revived that dead board yet.  I may have one of those with a faulty board and I have Toomim looking into it for me...



that sucks.   as always  try a lower freq.

Thanks Phil, I lowered the frequency to 550 and that board came back to life...whew!  It doesn't seem to like running at 600.  I'm going to let it stabilize overnight before I do anything else to it.  In the morning I'll try different frequencies to see how close I can get back to 600.  It's holding right at 12.66THs on the Kano pool at the moment but it's only been running about 30 minutes so far.  Grin

EDIT:  It is now up to 12.97THs on the Kano pool...if it stays like that overnight then maybe a frequency of 550 will be alright!  Cheesy  The specs for an S9 Batch 3 is 12.93TH/s ±5%  Grin  That ±5% hashing range is 12.18THs and 13.58THs so even at a lower frequency it's right in the mix there.  The HW error rate is 0.0008% so that is looking great!

I'm glad to see that we got that long block out of the way...  Cheesy

Well, it's been 24 hours with my S9 and the third blade simply will not work.  We first dropped the frequency to 550 to get it back online but it eventually dropped out again.  Then we dropped to 500 to get it going again and it eventually dropped out again.  Now we can't get that board to hash at all and I will have to start trying to figure out how to get this thing replaced...bummer!  Angry

We disconnected the power from the bad blade and now it's just hashing on the 2 good blades...