Re: Bitmain's Released Antminer S9, World's First 16nm Miner Ready to Order
Are you saying I should unplug the ribbon cable from the far right board and plug it into the open connector (far right using your orientation)?
Maybe yes. Just to be very clear you would not disconnect the ribbon cable on the hashboard end, you would disconnect it on the controller board end and then plug it in to the open port on the controller board. And yes the right side board as viewed from the front.
EDIT: I'm sure you probably understood me correctly I just don't want to be responsible for giving advice that causes someone to do something crazy like running a control ribbon between two ports on the control board and frying a very expensive miner.
Yes, I understand. I did not try that yet.
After trying to flash with the new 600Mhz firmware and having it fail, I reset to default settings, then lowered the freq to 587Mhz and it has been running stable for a little over an hour with no crazy readings.
I'll let it run for an hour more and if stable, will try to bump it back to 600Mhz and see what happens.
I'll update and post a screen shot in an hour or so.
Thanks for your assistance.
