Re: Trying to make a list of the rx 480's hash rate power and settings etc.
wattman keeps messing up and changing my 2nd cards settings to N/A and causing it to run at 96c with only 1400 rpm fan.. :/
okay re set wattman to stock on the two cards.
how many cards just 2 correct.
card 1 all auto until you reach the fan
on the fan
do 2000 4400 for fan speed
do 80c 60c for temps
do -28% for power
hit apply
card 2 all auto until you reach the fan
do 2000 4400 for fan speed
do 80c 60c for temps
do -28% for power
hit apply
you should get about 24mh + 24mh
now my pc is 100% for eth mining
I think you are trying to do other shit while mining?
Is this correct?
photos of a simple wattman tweak
re set all gpus in wattman to stock
boot
then leave gpu freq
on dynamic
voltage on auto
ok i see what you are doing.. you are forcing the cards to go to powerstate 4 or so by limiting the power..
ill give that a try. since the power part isnt resetting, its the clocks part that is messing up in wattman, i see yours is too.. it says N/A for everything but the last one.
yeah all the fan settings stay stuck when set which is good as gear is in the 63-66C range and fans are not too loud.
and all the fan settings come back after I boot.
which is easy.
then I only need deal with power limit which also stays stuck when you reboot. I tried everyone from 0 to -35.
My best results are in the 22-26% zones. and i only need worry over that one number.
Since I plane on :
2 three card rigs
5 two cards rigs
total of 16 cards. checking just the power limit number is soooo much easier then doing all the voltages.
Lastly the only tweaks are coming right here:
same shot no highlights
