... In the console you can use> getpeerinfo to see the version and blockheight for each of the nodes you are connecting to. could even edit the solarcoin.conf file to start with nodes that are both 2.1.6 and have blockheight similar to figure shown in Chainz explorer.
https://chainz.cryptoid.info/slr/#...
This was very helpful, thank you Nick!
To be clear, getpeerinfo reports the starting height of the node trying to connect to you. If the starting height is less than the height of your node, your node will push its inventory to the requesting node. It is NOT the current height of that node, just the height at the point in time that it connected to you.
-Steve
I can't get the new wallet to run on my XP machine. I did a clean install of the blockchain, and restored a wallet image. Added only peers from 2.1.6, etc. I have a windows 7 machine that does run the wallet, stays on the right chain, but reports a higher balance than what's currently in the wallet.