Re: ADVICE - One board on S7 shows zero as temp and HIGH HW errors ???
Hi All
All of a sudden my S7 has developed a problem as in pic below....It will run for 30 mins or so then it starts 'beeping' and stops mining and the temp shows 100 !!!
Anyone got any ideas ?
What board is it (i think it is the furthest from the ethernet port) ??
ALSO is it ok just to power one or two of the 3 inputs on the faulty board ??
I have tried various psu's and still get the same and each PSU powers ALL boards...as obvious.
Cheers
All of a sudden my S7 has developed a problem as in pic below....It will run for 30 mins or so then it starts 'beeping' and stops mining and the temp shows 100 !!!
Anyone got any ideas ?
What board is it (i think it is the furthest from the ethernet port) ??
ALSO is it ok just to power one or two of the 3 inputs on the faulty board ??
I have tried various psu's and still get the same and each PSU powers ALL boards...as obvious.
Cheers
Hi,
Chain 1 is the 1st board on your right when you are facing the front of the miner (with Ethernet port).
It is ok to run just 1 or 2 boards. You just have to disconnect the power and data cable of the faulty board.
Cheers, so what i thought was correct then, board one is basically opposite to the PCIE supply for the control board..
What i also asked is it possible to run one or two of the inputs (out of the 3) on the faulty board ?