Post
Topic
Board Mining (Altcoins)
Re: Caution! Pandaminers catching fire!
by
Oklawolf
on 05/06/2017, 22:14:52 UTC

no they are using 5 and splitting  2  into 4

so
1 single 18 gauge
 1single  18 gauge
 1 single 18 gauge

then a single 18 gauge that splits into 2 single 18gauge
then a single 18 gauge that splits into 2 single 18gauge

and every photo of every burnt  setup shows the melt starts by the split cables.

I mention that this psu should not be used long term more then one time in my review and that I went to a rosewill tokamak 1500 watt with no issues


Yeah, that's completely irresponsible engineering right there. Too few conductors with too few connections to the hardware. And with wiring like that, I seriously question their "1600W" unit is capable of anywhere near that mark over the long haul. If it is, it's a fire hazard because the cabling simply can't support it.

Stuff like this sickens me. This crap is going to burn someone's house down.

FYI, those Tokamak units throw a ton of EMI back into the power lines. I just pulled one out of my farm because I couldn't review power supplies with it running at the same time. Too much extra noise in the oscilloscope. They kill AM radio for a block, too. I have another 1200W Enhance Titanium doing the same thing which will also come out of the farm soon. Other than that, they are good units. I'd have just kept using it if I wasn't a power supply reviewer, but I hate shutting the rigs down just for load testing so I'm migrating to units that don't do that.