Well, I got a Skylake Celeron (G3900) CPU running on this Gaming M5 board and no change. Still boots to a blank screen whenever I enable 4G/crypto option. No cards installed. What did people do to get this to work?
Try following steps in BIOS:
1. Set PEG0/1 to AUTO
2. Enable above 4G enconding
3. PCI Latency timer 64
4. Initiate Graphic Adapter set to IGD with 64 memory (and connect the monitor to internal HDMI port if not done anyway already!)
5. Win 8.1/10 set to DISABLED
6. Win 7 set to DISABLED
7. Set UEFI only
It's important that you install Win10 in UEFI mode - if you have any issue that you cannot install Win10 on empty hard disk after you configured UEFI only proceed with following steps during Win10 setup.
At the partition screen of Win10 Setup press Shift + F10 to get a command prompt
Type this (hit enter after each)
diskpart
list disk
(will show you a list of attached disks, the one you want to install to should be 0)
select disk 0
clean
convert gpt
exit
then refresh the partition list and install Win10 on the empty disk.
If you have your monitor connected to the internal GPU instead of one of the mining GPUs you have the advantage that even the 1st GPU can mine at full speed as it doesn't have to waste some performance for Win10 graphics rendering
