Re: ASICMINER Auction: 50 Block Erupter Blades CHECK OP FOR PAYMENT

pinwheel, has it been working well for you so far? so we just need to use 2 wires right?

Thanks! Appreciate the answer!

Quote from: lan787 on May 03, 2013, 05:59:58 PM

Quote from: bclcjunkie on May 03, 2013, 04:03:08 PM

hey guys,

can anyone point me in the right direction in terms of electrically wiring this board?

https://docs.google.com/document/d/1VMO3VfIBy3KIwUaaQ8XhKrSVEbXeeMEqsVhhk6Bz9io/edit?pli=1

so the doc says this:

1. The two poles for the positive polarity are identical when cabling from the PSU, so are those for the negative polarity.

i'll be getting myself a psu with 12v/10a output so when i bare the wires, how will i know which wire goes into which hole? the picture below belongs to LainZ and i'm trying to figure out how to wire the board when it arrives...

look at another side of the blade. You will see "+ + - -" marks. So + goes to + and - to -.

Take a look here: https://bitcointalk.org/index.php?topic=178275.msg1928057#msg1928057

Is it really necessary to loop back both terminals like this? I thought friedcat had said these were for chaining boards (ie. are connected already on the PCB). My plan was to use a 6 pin PCIe connector from an ATX PSU and simply twist the three wires together to connect just one +ve and -ve input.

2 wires will work the same, I connected first all 4 points, but now changed to two wires