Quote from: Darthswan on July 25, 2017, 04:08:42 AM

Quote from: Darthswan on July 20, 2017, 03:16:05 AM

Quote from: numnutz2009 on July 19, 2017, 06:52:45 PM

#2....that doesnt matter. like i said newer firmware required all 3 spaces for all 3 pools in the config page. so what works for 1 firmware doesnt always work for the later firmware which is why i mentioned this specifically.

#3....so even when the miner was reset and the default info was left that bitmain sets manually in the firmware it wouldnt mine? no static ip no pool info except the default info that gets entered when the miner gets reset right??

also does the log file show the boards as being detected?? and have u tried using the latest firmware for that miner??

I'm going to go back and run some checks. I'll let you know

I ended up talking the good boards and putting in the miner with the bad PCB. I have my full miner back and a dead miner.

that works too lol. if your in the us you should send the boards in to be looked at and repaired/replaced. its way cheaper than buying a new miner and you dont end up with a paper weight of a miner like you have now.