Hallo,

i'm totaly new in this totaly noob  . my hobby is a bit electronics and stuff, bult my self 3D-printer and co2 lasercutter. but mining is new to my (sorry for my bad Englis, i'm dutch)

last week i buy 2 MAT blades with 2 USB wired to it, the 2 USB goes to a powered hub in to a rpi. so i think (and hope) that the blades have a FPGA update from superman Jstefanop  .

i tray to run it but my program in linux skils are noob, i try to make it work with Minera, but its havy to understand. i reed this post a lot and also the total post "AlcheMiner/MAT New Firmware and BFGMiner Port Discussion" van Jstefanop.

do sombody know a post a bit easier to read oubout this matter, is it poseble to connect the blades to a normal pc, for testing, so that i can learn more about Bfgminer ( i use win 10).
I have a lot questions, but were is a good start for this matter

a play a bit with putty, to tray to install bfgminer (but if i tray to connect to Minera via putty, i stuk by the password, so no install bfgminer custum  )

well you read i m a totaly noob in this materie, but if sombody have the patience and the time...    every tip is welcome

(i have some gridseed 5 chip miners that i connekt to a other rpi and Minera, i works fine. that is my only experience for now)

please help 

thanks for reading my post