Re: Bitmain looks like they're releasing a 15GH/s DASH miner called the AntMiner D3
After 5 days of D3 mining, I noticed that sometimes one of boards just turn of (this happens on different D3 devices,not just one), temperatures are ok, boards temps are max 70-71-72-73C. After
If they are really that temp in C, they have probably melted into a puddle!
M
my boards run as hot at 81c O_O I have the same issue where every couple days the 3rd board will kick off and I have to restart the miner, it's happened twice now
Is that really possible??
Maybe I'm behind times.
M
check this out
/// you can see it in my antminer d3 review video
https://youtu.be/Wg1H1YOSW4E
or there's a screenshot pulled onto the blogpost of the bitmain antminer d3 review
http://voskcoin.com/official-bitmain-antminer-d3-review/
Your temps are too high. I found that the D3 has more HW errors running 70c+ and a card will stop hashing then miner has to be reset. To fix this problem I down clocked to 456m and fan at 70% results where 16000 mhs average almost 0 errors and stable hashing no resets needed anymore. I also found you can set miner to 80% fan speed and miner will stay cooler ,but loud. Factory default fan speed control sucks. see below
Factory settings: Frequency (default gh/s 17000) Fan speed: changes depending on temp (not great)
Optimal settings: Frequency (default gh/s 17000) Fan speed: 100% Miner runs cooler ,but very very loud
Medium Settings: Frequency (default gh/s 17000) Fan speed: 80% Miner runs cooler and somewhat loud less errors cooler temp.
Low Settings: Frequency (456M gh/s 16000) Fan speed: 70% not too noisy very stable.
But you void your warranty as you are touching the frequency...