I had similar experiences with a bunch of mixed brands RX480 running over clocked on SMOS
I established a working setup by starting without ANY OC settings in SMOS
Once this works for a few hours you can start changing 1 parameter after another, every few hours, not all at once
This way you will figure out which parameter or value is too aggressive and you will scale back.
Takes a lot of time but once running it hardly crashes.
Dear community,
I rely on your support. Days and nights I am struggeling to get SimpleMiningOS working with my four RX580 cards (bios flashed).
They work stable under WindowsX64 under Claymore XMR 9.7 with the following settings:
-cvddc 900
-cclock 1200
-mclock 2080
But when I try to use SimpleMiningOS Claymore claymore-xmr-v10.2 it will run into a reboot loop.
I have tried the following settings in SMOS - unsuccessful:
Core MHz: 1200
Memory MHz: 2080
Core Unvervolting: 900
Powerstage: 6
Target Temperature: 75
Minimum Fan speed %: 30
Tried the same with SMOS claymore XMR 9.7 without luck.
Tried also for ETH Claymore 10.0 with following command in SMOS:
-wd 1 -r 1 -epool europe.ethash-hub.miningpoolhub.com:20535 -ewal user.1 -eworker user.1 -esm 0 -epsw x -allpools 1 -mport -3333 -asm 1
What am I doing wrong?
Any help is much appreciated. Thanks and kind regards,