Hi all,
I'm having issues with my H110 Pro BTC+. It refuses to boot (don't even get BIOS) with more than 9 GPUs installed, on the 10th i get the issue, 9 works fine. I've followed the miners guide and ensured both molex plugs and the Sata connector (so 3 in total) are connected on the motherboard and are also using 3 separate cables back to the master PSU. Can anyone help? OS doesnt matter since it doesnt get that far.
Setup:
H110 pro BTC+
Intel G3930 CPU
4GB Ram
500GB Sata HDD
ATI Rx Vega 64 GPUs
3 x Corsair HX 1200 PSUs (1200 Watts each).
Is there perhaps some sort of undocumented issue with the board not supporting these cards? They require two 8pin PCI-E power connectors each, my power draw should be fine though, I have one PSU dedicated to the mother board and the other two PSUs for the GFX cards. Apart from that anyone got any bright ideas?
Hi,I'm having issues with my H110 Pro BTC+. It refuses to boot (don't even get BIOS) with more than 9 GPUs installed, on the 10th i get the issue, 9 works fine. I've followed the miners guide and ensured both molex plugs and the Sata connector (so 3 in total) are connected on the motherboard and are also using 3 separate cables back to the master PSU. Can anyone help? OS doesnt matter since it doesnt get that far.
Setup:
H110 pro BTC+
Intel G3930 CPU
4GB Ram
500GB Sata HDD
ATI Rx Vega 64 GPUs
3 x Corsair HX 1200 PSUs (1200 Watts each).
Is there perhaps some sort of undocumented issue with the board not supporting these cards? They require two 8pin PCI-E power connectors each, my power draw should be fine though, I have one PSU dedicated to the mother board and the other two PSUs for the GFX cards. Apart from that anyone got any bright ideas?
I am facing the exact problem like you!!!
With 9x vegas it´s running nice, but when I connect 10x nothing happend. I am not even able to boot inside bios. Monitor is off and thats all...
I am was contacting asrock support few times, they are told me lots of sh..s, but at the end, they are sent me a new bios for mobo. Unfortunatelly I am was unable to try it because the rig is in remote area...
If you want to try, I can send it to you.