Re: Antminer D3 Blissz firmware (21/11 update available!)

Well this looks my stable peak - https://imgur.com/a/v7X9J im worried abou that last chip having 77 temperature do u think it will be alright ?

a really nice overclock. What are your voltage settings? Your temperatures are perfectly fine. I can't give you any guarantee, but if you have cheap electricity and can handle the noise I would let it run at these speeds.

If you're worried about the last chain, you can clock that chain down a bit to i.e 575 Mhz and lower the voltage a bit too to get it to ~73 degrees as well. Let chain 1 and 2 run at the settings as they are now.

I was playing with the chain a bit but when i change voltage of 1 chain it somehows affect the others to and i get HWS / high temps ? MY current voltage settings are 20 on all chains , i tryed nearly all of the high combinations this one seems to be the most stable with 4-7 HW for hour on middle chain as i said only things that worries me is the last chain with 77 degree atm, Might aslo meantion my D3 is in ventilated room with room temp around 0 degree

Hi,
I would reduce the frequency a little for the last chain which seems always to have higher temperatures (I have 4 D3s and I see the same phenomenon). This is probably due to the way the fans are pushing the air through the body of the miner, which causes more air to flow to one side, affecting the other side where the 3rd chain is located. 77 deg. is ok, but I would not let it run 24/7. The highest temp. I would run any of my D3 miners on a 24/7 basis is 75 deg. C. and even then, one would get more HW errors than with lower temperatures.

Thanks i wanted to know the peak ima get it to 75 Wink

also im not getting HW errors after 1 hour i got just 4 HW only on middle chain