Hello, have some newbie questions.
1) Is ZM's miner not working in nv0019-1.3? EWBF works great but every time I attempt to use the dstm it doesn't work. Either it says "this screen is terminating" and then it eventually reboots from low gpu utilization or it says "no miner has been attached to this screen."
2) Is there a way to execute setting changes done in 1bash without rebooting?
Thank you
Regarding 1, as best I recall, there was a problem with ZM in 19.1.3 where either the location or the name of the ZM miner in /home/m1/zec/zm was out of sync with what is being called in 3main. I don't have that version handy or else I would check for you. If you go back several pages in this forum, I am sure it is discussed in detail there. As for 2, the way I do it is to kill the miner screen and wait on the watchdog to see that and kill/restart 3main. However, that can take about as long as rebooting depending upon if you are on USB or SSD.
Hope this helps.
I'm not sure if i doing it right but the fastest way i know is just close the console and start a new one. Not the green Guake terminal. The black standard terminal. It kills the miner and restarts mining.