Post
Topic
Board Mining (Altcoins)
Re: Antminer D3 Blissz firmware (23/11 update available!)
by
may142012
on 25/11/2017, 01:34:11 UTC
Guys, please help me out this problem. Today, i had received my miner from Bitmain, so i booted up:

- Two fans are spinning and working.
- The controller and ethernet port are working.
- Three hashboards are all working, all three had showed no signs of xxx or anything related to defective. (Tested each board before plugged in all three).
- The power supply (Bitmain's APW3++) is working as well as all pins
- I am using a power cable 10A - 250v.

Results: If i plug the PSU more than 2 hashboards, the miner will begin to reset every 5 secs, then loop.

So what is the problem here? Is it because my outlet doesn't have enough power to run it? You know something about circuit breakers and sh*t.