25/11 v2 recommended UPDATE
I really recommend to update to this version as it brings more stability / + small hashrate improvement
Download:
https://mega.nz/#!DowkVLgD!qVz5xnC2tGpUKKcjd6_kdkVjIwSG7-EBUkq1e_rX5Mg
Changes 25/11 v2:
- Hashrate calculation is now according bitmain stock firmware (displayed hashrate is ~3% higher now)
- + ~1% performance improvment by providing the work faster to the ASICs
- removed dev pool from miner status page to speed up webinterface and avoid confusion (exact dev mining details are visible in the kernel log)
Changes 25/11:
- fixed auto reboot on low hashrate / xxxx
- fixed issue where temperature readings could be wrong
- fixed fan error on some units
- improved stability
- allows for zero RPM fan (all custom fans should work now)
- increased upper limit frequency for overclocking. (not recommended though
)
- dev fee kicks in a bit later now after changing settings
know issues:
- switching pools can sometimes cause the miner to wait for work for 10 seconds.
happy mining!
I really recommend to update to this version as it brings more stability / + small hashrate improvement
Download:
https://mega.nz/#!DowkVLgD!qVz5xnC2tGpUKKcjd6_kdkVjIwSG7-EBUkq1e_rX5Mg
Changes 25/11 v2:
- Hashrate calculation is now according bitmain stock firmware (displayed hashrate is ~3% higher now)
- + ~1% performance improvment by providing the work faster to the ASICs
- removed dev pool from miner status page to speed up webinterface and avoid confusion (exact dev mining details are visible in the kernel log)
Changes 25/11:
- fixed auto reboot on low hashrate / xxxx
- fixed issue where temperature readings could be wrong
- fixed fan error on some units
- improved stability
- allows for zero RPM fan (all custom fans should work now)
- increased upper limit frequency for overclocking. (not recommended though
)- dev fee kicks in a bit later now after changing settings
know issues:
- switching pools can sometimes cause the miner to wait for work for 10 seconds.
happy mining!
The download link is dead
ya i found this https://www.3m.com/3M/en_US/novec-us/applications/immersion-cooling/
any one know how to get that stuff or where to get , thanks may142012 for the word to search for
any one know how to get that stuff or where to get , thanks may142012 for the word to search for
Sent you the link of the fluid to your inbox.
From what i know, you need a big tank that fits all of the boards from your miner, a top tank that install the Cooling Coil to do two-phase operation, and of course the 1 gallon fluid that cost $300.