***************Well it lasted an hour and then the same board crapped out.****************
It ran the entire time without an error. Just hit the refresh button and 60+ in last few minutes and board that one board stopped


Ok so I don't know if its juat another day or the new firmware.

I put the bad board back in after the new update. I now have Machine 1 up and running for about 20 minutes and no HW on the "bad" board.


I'm running at 15.3

The bad board is clocked down to 350 and I have to use 10v. But at least its providng 4000+.


Not sure I feel safe leaving it unattended. Not because it will burn out but when the board fails it still sends power to the board and its just a waste.


Blissz can you shed some light? these boards do seem to be tempermental day to day.