Re: Launching the Antminer L3+, World's Most Powerful and Efficient Litecoin Miner

Hello;

I use nicehash for my L3+ but 1 machine is always lower speed and time rather than other. Speed is around 150-200mhs , time is also low. All the machines settings are same. Whats the problem for you?

https://imgur.com/ohmuVJI

Thanks a lot

That is normal.

My miners also fluctuate a lot. You need to look at the estimation bar at the top. The calculated speed is the important one of all miners.

i dont think so, for example 2 min. ago i checked it shows 0.2 mhs. is it normal? but now it shows 172 mhs. Just this machine have big fluctation between 0.1 mhs - 270 mhs.

Well if you are unsure, go and check the stats of your miner. If your Nicehash calculation is normal, just the "accepted speed" figures of the single miners does not check out it is all ok.

I have miners jumping 800Mhs and then a couple minutes later 170-300Mhs. But my calculation of all "accepted speed" is more or less spot on and the payout is also as it should be with a flat Mhs rate (without fluctuation)

But like said, as long as no board is down, dont worry too much. Same goes for Prohashing or H2C or whatever other pool there is.

Hello;

I checked miner status, there is a lot of X. I read bitmain forum about potantial failure page, Reason: The chips are damaged, which lead to the entire hash board

running abnormal.

Resolution: Remove the hash board to repair.

I launched machine 1 days ago. Sad

https://i.hizliresim.com/a1vldd.png

Try to reboot the miner over your online control. if that does not fix the problem, reboot it to shipping settings. You can do that over the black pin on the front next to the ethernet port. If that still does not fix the issue, check your psu cables and if that is also not working your board might have been broken even before you received it and it needs to be replaced

Hello;

The problem is caused by the power supply pin enterence. When i checked psu pin, one of them is not fixing well to socket. Now it's stable.

Thanks for your support