Need some assistance/advice with my brand new Antminer D3.
I'm not trying to waste anyone's time so I'm going to try and be as detailed as possible so people can diagnose the problems I have.
Alright, the first day I get the miner. Runs for about 3-4 hours. Has red "fault light flash"--> check and see every chip has a red "x" restart and the entire board 3 just no longer showed up on the page.
I went and upgraded firmware and now all three are back up but the third only shows "54" chips while the rest show 60. I am unsure why this is.
It's been going well on Antpool now for about 24 hours but I've noticed it's got millions... MILLIONS of hardware errors. I am unsure how to fix this or what it means.
Here's my situation: Miner is a room with ac + window open. (80F- 60F at night). The power supply is the APW3++ from Bitmain. I'm in USA so I believe it's 120 volts if that matters.
Everything else seems to be set to default. You can see my recent miner status here: It seems to have improved hash rate for the time being?
https://imgur.com/oqT12HfPlus on a side note, it randomly hits 0.00 hash or something on antpool charts:
https://imgur.com/a/d54aGAnyways, should I try to use my warranty to get it fixed? What are the benefits of using this "firmware" and how is it possible that it would be quieter faster hashing, and less power? Can't Bitmain just update theirs? I'm very new to this and would love to learn so all advice is greatly appreciated.