Hi,
I seem to be getting the following error popping up about 4 to 5 times whenever claymore starts:
GPU#0 got incorrect share. If you see this warning often, make sure you did not overclock it too much...
Then I dont see the messages for a while, but, when the dev fee kicks in it switches pools, finishes and tries to pull from my configured pool, then I see the errors 4 or 5 tims again, then nothing for some time, rinse and repeat.
I noticed when claymore starts up it setting the -h parameter to 1800, looking at my hash rate per card it seems to hover around 745 - 748 H/s. Do I need to drop this -h parameter down a bit?
What is the recommended setting for the -h paremeter? I have 2 x AMD PowerColor Red Devil RX 580 Golden Sample with BBT modded BIOS applied, I obtained the BIOS from
here.
Any thoughts/tips/suggestions much appreciated.
Use the 9.7 version of the miner. You may have to go back to an older version of the drivers it requires 15.12 drivers or at least it recommends them.