Can anyone tell me if after having used the Blissz firmware, is it still possible to replace the defective board by sending it to the bitmain?
It's that with some faulty ones, but I used his firmware.
It's that with some faulty ones, but I used his firmware.
how could they find out? tehy just get the boards with the asic's and not the control board
or am i wrong?
right if you send only hashboard.
@festim dont mining on antpool ... darkside
@mkmfins ... yep probably burn some of ... lower frequency for long life ... worst default (way) of humanity -> "Ever want more". if everyone go to 400Mhz , we all get more profit cause difficulty lowering and watts to :s but it s a dream i think
And for some people asking if mods will come for L3+ or S9 , i m following this thread & dev since begining , and if i'm right : Blissz do not have those miners , so it's impossible to have some test to mod it unfortunalty for us ... i just connect one S9 it 's like ... euh ... plane reactor in my living
and if some of you have break one or want to donate for the time to create mod , i 'm sure it's welcome
My question is because I'm from Brazil, so I send that shit back to them to fix it, I'm going to spend more money, I'm going to risk having to pay more for customs, it's too complicated ...
So my doubt on whether I can continue to use this faulty board, trying to put the Mhz and Low frequency ...
But if I send only the bad cards to BitMain, I can send them without fear that they know I put the Blissz firmware, right?