Re: Official FutureBit Moonlander 2 Driver and Support Thread
Hey guys..I got a couple questions here..so I am currently running MACOS high Sierra, and apon following the walk around to download the driver, everything works great!(thanks to the team to tackle that obstacle) so my miner was currently running at stock core and memory voltages, 756mhz, 4.04/4.17/4.28h A:1362 R:3 hw 50/.14% (estimated numbers from my last run in a 4:45 hour timeframe)
Question 1. Do those numbers look acceptable to you guys? It doesnt seem bad to me but I want to shoot for the 5-5.5 mh/s so I might jump into tuning slightly today.
Question 2. So my miner was running one night for 16 hours straight(unfortunately dont have numbers from that) then it randomly stopped hashing and basically went dormant..*Is this normal? I want it to get to a point where I can set it, and forget it, maybe check on it a couple times a day but not babysit and worry about it stopping.
Question 3. Is there an update for the driver so when I go to install the new one(as of 12/14/17) I have to do the walk around again just to update?
Question 4. So every time I open run moonlander 2 terminal(for Mac) I constantly have three pools showing but only one of them is the one Im actually using, and every time I go and delete the other unneeded ones they keep constantly showing back up even after I close/save session and start the program back up again. Any reason for this??
Thanks everyone!!
Question 1. Do those numbers look acceptable to you guys? It doesnt seem bad to me but I want to shoot for the 5-5.5 mh/s so I might jump into tuning slightly today.
Question 2. So my miner was running one night for 16 hours straight(unfortunately dont have numbers from that) then it randomly stopped hashing and basically went dormant..*Is this normal? I want it to get to a point where I can set it, and forget it, maybe check on it a couple times a day but not babysit and worry about it stopping.
Question 3. Is there an update for the driver so when I go to install the new one(as of 12/14/17) I have to do the walk around again just to update?
Question 4. So every time I open run moonlander 2 terminal(for Mac) I constantly have three pools showing but only one of them is the one Im actually using, and every time I go and delete the other unneeded ones they keep constantly showing back up even after I close/save session and start the program back up again. Any reason for this??
Thanks everyone!!
1)Numbers look good
2)Download the new bfgminer version that addresses this issue
3)Your confusing the silicon labs UART driver with my bfgminer mining software(that includes the driver for the Moonlander). You don't need to reinstall the UART driver and do the workaround again, only thing you need is to just download the updated binary and run that instead of the old one.
4)Do you have a config.txt file that your running? This picks up settings as well, also make sure your not running off the desktop image when you download the driver, and save the bfgminer folder somewhere on your hard drive, otherwise changes you do to the start-moonlander file wont save.