Re: [Work in progess] Burnins Avalon Chip to mining board service

Quote from: Defkin on July 06, 2013, 11:10:57 PM

Anyone know if there is electrical insulation (thermal interface material) between the heat sink and the board?

Just thermal paste + the insulation of the board.

Quote from: alexuk on July 05, 2013, 04:32:04 PM

Burnin - ETA on website + ordering?

Next week.

Quote from: RoadStress on July 05, 2013, 04:33:30 PM

Quote from: Foofighter on July 05, 2013, 03:37:29 PM

Hey burnin,

Bitfury chips are now for sale^^, so lets start to think about REV.02 of Bitburner.

see here:
http://www.bitfurystrikesback.com/shop/
https://bitcointalk.org/index.php?topic=250249.msg2661326#msg2661326

regards

I don't think punin will give the master board schematics after reading from here: http://www.bitfurystrikesback.com/product/bitfury-55nm-asic-h-board/ "16 chip Hashing Board to be used with the Master board (or separately if youre a real hacker)"

Are you a real hacker burnin? Will you offer mining board service with Bitfury's chips? If yes how are you going to get the schematics of the boards?

Isn't this whole thread proof enough when it comes to my abilities to develop and build products that actually work?
I don't need schematics to create a bitfury mining board.
All the infos needed to adapt the bitburner to bitfury's chips were already released.
(Pinout and protocol)
Once the Avalon stuff is all done i'll do a Board with those chips.

Overall status:
Wrapping up the last few changes to get these boards mass produced.

cgminer screenshot for a long run at 320Mhz - 6.4Ghash/s, about 0.12% HW errors.
The reported temperature is the actual board temperature, chip surface measured ~50°C.