very porous and could be smoothed out for better heat transfer to a heat sink.
I started to reverse engineer the board completely.
High Res warning
http://wtfmoogle.com/wp-content/uploads/2013/07/bepinouts1.0.jpg
I have a feeling the speed of the asic is controlled by the firmware in the attiny
I would kill for a full detailed schematic or chip spec of the asic.
Can anyone get me one? Firmware of the attiny would be nice too
I started to reverse engineer the board completely.
High Res warning
http://wtfmoogle.com/wp-content/uploads/2013/07/bepinouts1.0.jpg
I have a feeling the speed of the asic is controlled by the firmware in the attiny
I would kill for a full detailed schematic or chip spec of the asic.
Can anyone get me one? Firmware of the attiny would be nice too
nice to see some brave exploration.
You might try using acetone to remove the solder mask, perhaps test on a salvage/junk pcb first.
And of course use proper safety measures - acetone is pretty nasty stuff.
As far as firmware - it would seem Sir Friedcat is the only possible source.
EDIT: Ha - after a quick look at your blog, I'm guessing you can handle a little acetone
