I have an antminer D3 that’s only a few weeks old. It had the firmware issue where one of the boards would randomly quit working. I updated the firmaware and haven’t had an issue until today. It had a board with all x’s. So I restarted the miner and now it is hashing at full capacity but one of the boards isn’t showing up in the miner status page. The hashing numbers from my mining pool confirm it’s working at full capacity, but it seems the miner isn’t recognizing the board.

I have seen non functioning boards act like this, but never heard of a board not being recognized but still functioning.  Anyone run into or hear of this before?  I’m not too concerned about it short term but I’m not confident in its reliability long term with it acting so weird.

I have rebooted the miner a few times and it does the same thing. I haven’t done a reset or reinstalled the firmware since the miner is remote and I won’t be on location for a few days.

Any help or experience would be super helpful, thanks!

https://imgur.com/gallery/iJ772

If you look at the total hashing is says 17gh but that is significantly more that the total of the 2 "seen" hash boards.