I'm in USA so 120 volt or 110 not sure.
What is the highest I can put my ASIC Voltage to without it breaking/popping any circuits?
Power cost is not the concern and I'm pretty sure the max power draw is 1300 watts from the AMP3++ power supply from bitmain?
I want highest hash rate possible... POWER cost is not a problem the only problem is popping a circuit!
Thanks
Your supply will only give you 1200watts at 120v. So you can't go much higher without killing the supply or starving the boards.
The above is correct but to answer the rest of your question : look in your breaker box. are they 15amp breakers or 20 or what..
take that and x 110 (thought technically 120/240 - real world best to base your math on 110/220) this will give you the wattage that
the WHOLE circuit can run..at MAX if your wires are crappy and barely acceptable for the amps you will be drawing they will get hot.. (gotter the closer you get to max..) so lets say 15 so that is a max of 1650.. (oh wait keep in mind your psu will draw MORE than the 1200 it is giving to the machine.. by like.. alot. ) so realistically.. you can do it on 15 amp breakers IF you have pretty much NOTHING else on the circuit.. how to find out? flip a breaker.. what all went off... that;s all on the same circuit. voila.
my bad.. the rest of HIS question. sorry still getting coffee in me.
I think you missed my question. I understand that my power supply will only use up to its maximum but what ASIC voltage setting is that? 13/13/13 or could it be 1/20/1 or what happens if I do 20/20/20 is it going to pop a circuit? The whole point is I'm trying to not pop a circuit at all so let's my setting is 15 amps (just guessing) what does that come down to in terms of asic voltage 13/13/13? 15/15/15 or how can I know? Flipping a breaker is what I'd like to avoid completely!