Re: Which USB hub to use with Block Erupters or K1? A List.

Quote from: realestone on July 31, 2013, 04:49:49 PM

Quote from: miter_myles on July 31, 2013, 04:15:54 PM

Quote from: realestone on July 31, 2013, 04:00:29 PM

has anyone ever tested out this hub? http://www.amazon.com/Juiced-Systems-USB-3-0-2-0/dp/B00B1WMYGO

I noticed that one too.. got a mix of USB 2.0 and 3.0... wouldn't work with the Pi right?

according to the specs on their site:

\\
4 Upstream and down stream USB 3.0 ports. 9 Upstream and down stream USB 3.0 ports. 480mpbs and 5gbps transfer rates with on/off LED indicator with power switch for each port. Supports hot swap plug and play devices.

**Does not need power supply to operate but recommended for high power consumption devices**

Hub weight: 140g
Cable Length 100cm
Power Supply 3.5mm DC 5v jack.

//

Can't find the Amps..

yea i couldnt either

Speedy response back from the company contact on their website... states the following:

"I believe, the units are as follows : 5 Volts , 45 Watts 9 Amps - 900mA each USB port."