Ninjastic
PostEdited versionsQuotes to this post
Post
Topic
Board Mining (Altcoins)
Re: Gateless Gate Sharp 1.2.4: zawawa's open-source dual ETH/XMR/PASC/LBC/FTC miner
by
UnclWish
on 22/01/2018, 16:45:04 UTC
Quote from: treanski on January 22, 2018, 04:24:49 PM
Quote from: UnclWish on January 22, 2018, 04:05:19 PM
Quote from: maverik77 on January 22, 2018, 01:42:17 PM
I could go even more on type 1000h each card but there are some errors in more then I prefer to stay on 970h with consumption about 800w

overtool 1240 910 memory 2060 910
Why 910mV? As I know the recommended values for core and memory voltage is 850,862,875,887,900,912,925 etc. It's devide by 0.25mv/2.
Can controllers change voltage so small steps as 0,01mV?
you can adjust with ab or trixx +-100
But 100 is not a limit... -100 it's 950-1050 mV. On Sapphire RX 580 Nitro+ 8Gb(Hynix) I use 1250/2125MHz with voltages 875/850mV. On cryptonight lower than 100W power cons.
If use HWInfo, it show that core voltage jumps by steps by 0,12-0,13V. I think that setting 910mV will give 912mV. So as 911-917.
But it's not exactly... and need to check...