Re: [POOL] GigaRho Profit-Switching Multipool (Scrypt,x11,sha256,neoscrypt,blake2s)
Thanks. Double word score for a very thoughtful and thorough answer. Certainly exceeded my expectations there - I didn't think anything questionable was happening, but it just seemed odd. The pending balance fine so I think you essentially nailed it.
I tried to ask a different question earlier and had it booted back by the"lords of the board" so going to word it differently and see how that goes. On MRR I have a choice of US, Europe, and typically Singapore for rigs. Do you have any suggestions about whether it matters or if one would be more optimal than the others on your site? My naive understanding is that with higher diffs the latency matters less, but would like to make sure I am as optimized as possible.
thanks again. I didn't back off the SHA as expected - assume you don't mind
. Still bizarre it's cheaper to rent the entire rig for a month than run my own but so be it until solar gets fixed for the S9s and particularly the T9s Absolutely, and no problem, there are many things going on so even with what I listed there are other factors like BTC exchange rate as its risen quite a bit in the past few days. Some alts follow while others are stagnant at the moment.
As far as MRR locations, I'd say USA is probably a best bet for multiple reasons besides just latency such as stability. Latency plays a bit of a factor when the pool is sending job shares to each miner and needs to speak back and forth to the equipment especially when being relayed through MRR in a "hands-off" sort of approach. The cost effectiveness of a plan then also needs to be taken into account, if Singapore for example were to be a much cheaper option to rent over a period of 24hrs, then you would need to decide if that latency is going to reduce the hashrate earnings beyond what other locations would.