Quote from: ckai93 on February 19, 2018, 02:38:14 AM

a few hours back pool shows that rig went offline but the miner still submit shares.
i've restarted the miner and still submit shares as usual but pool still doesn't show that.
been in touch with ethermine support but they insist that it wasn't a server side fault.

still not sure if it was a pool or miner issue but till then, i'll continue using claymore.

Wow, IP hijacking attack?! The -proto 2 or -proto 3 has nothing to do with this BTW. If the attacker has spoofed the IP address of ethermine, there is nothing we can do (and the same goes for Claymore). Until the stratum protocol is encrypted or at least authenticated, these things can happen and the only defense is to check your stats from time to time. Please note that IP hijacking happens not on your machine or your network but on the routers of your ISP or even some of the backbone routers of the Internet, so there is nothing you can do to mitigate it. Fortunately, these things are rare but they will be on the rise with the increasing popularity of the crypto.

Quote from: fadius on February 19, 2018, 04:37:47 PM

I tested 2.7a yesterday on an RX580 8GB ... seemed to work well, very slightly faster (~ 0.2 MH/s) than claymore at same core/mem clocks/voltages.
I like it and would definitely considering switching to it from claymore.

1 issue I noticed is that when I setup the monitoring port, I'm able to see the console output by accessing http://IP_ADDRESS:PORT however a monitoring app I used (claymore monitor on Android) is no longer able to get the stats. If I understood correctly, claymore monitoring apps should still work ?

thanks!

The remote JSON protocol is the same as the one in Claymore dual miner but the logs are obviously different (the one shown by http://IP_ADDRESS:PORT). Probably the tool you are trying to use is parsing the logs to gather additional information and is "confused" because it expects the logs to be the same as Claymore's character-by-character. This is beyond the scope of compatibility we are willing to provide as we want to add even more information in the console. Hopefully, with the increasing of the popularity of PhonixMiner, more tool creators will add support for our miner as well.

Quote from: strike101 on February 19, 2018, 04:59:03 PM

somethings weird both my rigs 12xRx570 temps just went up to around 75-79c , started around 1-3 days ago

they were previously hovering around 62-69c for weeks

1100 - 850mv gpu clock , 1950 - 900mv mem clock @ around 29.x mh/s

i didn't upgrade , change anything...

Check your OC settings (esp. core voltages) with something like GPU-z. The AMD drivers tend to "lose" some overclocking settings if the GPU is idle for some time but the Wattman still incorrectly shows the lower voltage. This will be fixed in 2.7b when we will finally provide hardware control setting integrated in the miner itself.

Quote from: Tranzius on February 19, 2018, 08:32:47 PM

Can someone help me with this? What does it mean? Showing randomly in miner..

"CMD command miner_file rejected: CMD is in read only mode"

thank you.

If you are not trying to upload epools.txt or config.txt files with the Claymore remote manager, then someone is trying to "hijack" your miner via the remote control port. Fortunately, you haven't enabled the full mode, so this is not possible but the miner warns you that someone tries to upload file via the remote management socket.

Quote from: Bigf00t on February 19, 2018, 10:15:49 PM

Please make a Linux version

We will, definitely. It would take some time however, so bear with us.