Post
Topic
Board Mining (Altcoins)
Re: HSRMINER Neoscrypt Fork by Justaminer - New ver,GTX 970,980,980Ti supported now!
by
stevascha
on 23/02/2018, 09:34:24 UTC
[...]
I will play with benchmark to find the best hashrate/watt settings, and find the perfect intensity. Do you have a tip for the GTX1060 3GB, just "trial and error", or let the default miner settings and drink a beer?

Default intensity setting is fine tuned for 1060, but you can try to change it if you wish. My advice is to drink some beer and relax a little while miner works  Cheesy

My advice depends on your current profit margin and % of electricity cost at the moment.

1. If your electrical bill is <20% of your gross income from mining, if it's winter time (cold), you just crank up PL and OC and intensity to the max and relax with some beer.

2. If your electrical is >20% but less than 33% of gross income, let go off the throttle a bit and get back into <25% zone on electrical. Add some harder liquor to the beer and relax.

3. If your electrical is >33% and BTCUSD is <$3,000 and you cant afford to buy beer any longer, then it's time to set PL to 50% or as low as you can go and switch to cheap vodka or some other substances so you still can relax Smiley

4. Finally, when you think it's over and mining is not profitable anymore... when you see Metroid show up with his suicidal ideas in this thread, you will remember the times when you had all your GPUs running at their max capacity and feel good about it Smiley

You can guess I'm running 1060's with -c 5 -i 16.5 and PL at 100% at the moment. Ambient temp is 3C and electrical is at ~18%. Don't even need my beer yet Smiley

hi dude, do you use this program? for now i still using klaust instead