Hey there, I got a few blades yesterday and I have read this entire thread, which has some amazing info!  But I am still having trouble!   This is what I got with 2 blades last night:


2 Generic PSU's papercliped.  17amp+ 12v.  2 individual molex strands cut and fed to blade. (2-4 yellows, 4-6 blacks) Direct from PSU
Blades configured properly for Deepbit and EclipseMC
For testing one blade is at 1.195 Volts  The other is at stock 1.05V
Both Blades on LOW,  With: Chip: OOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOO
Blades being cooled with a insanely strong blower blowing through them long-ways.  (at least several hundred CFM, they are only warm to the touch)


Blades basically won't work on DeepBit no matter what I try.  Every once in a while they send a few shares.

On EclipseMC the blades show between 1-8Ghash on the Eclipse control panel on the site.  When I compare the shares against a 5.6ghash Jalepeno they seem to be doing more work, but not that much more.   This is what the config page looks like:
Total MHS:   00000
Received:   0000000215
Accepted:   0000000000
Per Minute:   000.00
Efficiency:   000.00%
Up Time:   0d,00h,01m,41s

They seem to be restarting almost exactly every 2 minutes and 15 seconds, weird right?

I don't think its a power issue,  I am NOT using the proxy (the links are down and I'm not sure they are useful for other pools?)    


What am I doing wrong, is it a network issue with get-work?  They have been running like this for 8 hours now with same results.   Any ideas?