Ok, noobish question here. I have the latest (old blade) revision and for some reason when I connect it, All i hear are a few 'clicks' and then nothing.
Silly question: Did you perhaps forget to plug in the red fuse ?
The newest (old) blades have no red fuse? or did mine just really freaking ship without one.. Actually, I didn't get a Green connector either.. Did my blade arrive incomplete?
Ok... So my symptom is the same as this... except that I do have a red fuse, it is unbroken, and is inserted...
Yet same problem.. I don't get any ethernet lights on my switch, the blade doesn't appear to be doing anything, even though it sounds like it might be starting up. Those clicks mentioned plus a slight hum of a capacitor
Please help? :/
to provide stable power supply you must have 2 mm thick wire inserted into green connector on board. Loose connection can be a problem. Other reason, your LAN cable not connected properly. In this case blade is running but you will not see any light on network module. That can be due to LAN cable not attached properly or faulty cable, or because network module not incepted firmly into connector. Connect fan to connectors on board, and try again, if fan is running it is network problem. If fan is not running check your power supply and wires.