jstefanop,
Your opinion please on temps.
I have 2 of your sticks. One I bought from you on Ebay and the 2nd from Holybit.
Both sticks are doing great now that I have spent quite a bit of time tuning them. FUN hobby to be honest especially for mining n00bs

I am running both at clock of 796. Using a 6 AMP PS.
Both stick are running .70V on memory (I can get .68 on one) and .79V on core.
Error rate on one is less than 1% and the other is about 1.5%. The one I got from you on Ebay is the better stick. Not that it mattered really but the error rate is always lower on this one.
I use a heat gun probe tool to measure the small back heat sink and it runs about 153F. Knowing chips a bit 153F is OK.
So now the question. When I jump to 832 clock I get an error on both sticks under 3% but both show an error rate of about 2.4ish.
Still all good. BUT the back heat sink runs about 162F. I think this is pushing it no? FYI Ambient temp in my room is 75F average right now.
Is 162F OK for the back heat sink? What is the max temp on this to be careful of reaching? Back in my old chip days 175F was about it before stuff starts losing a lot of life big time.
Your thoughts on temps please

Thanks jstefanop. Your stick rocks for the hobbiest and I am loving them. I just don't want to go to far and I want to be aware of proper temps. I see some guys running these MAX out and they have to be smoking hot doing so.... Again your thoughts on temps.
Thanks,
Bob