Re: Design a physical Bitcoin - 5 BTC bounty + design credits + free physical coin!
Sorry but I dont understand the requierments very well.
- The coin should be 39mm in diameter. (1.53543 inches)
- The back side of the coin must have a 1 inch diameter "donut" so that when the coin insert is placed on the coin and the hologram over it, there is no bulge. Please see the example above. The inner part of the "donut" (where the coin insert will go) should be 25.4mm (1 inch)
- The hologram should be circular and 12mm (0.472441 inches) in diameter.
- The coin should be 39mm in diameter. (1.53543 inches)
- The back side of the coin must have a 1 inch diameter "donut" so that when the coin insert is placed on the coin and the hologram over it, there is no bulge. Please see the example above. The inner part of the "donut" (where the coin insert will go) should be 25.4mm (1 inch)
- The hologram should be circular and 12mm (0.472441 inches) in diameter.
WOW....
Thank you for pointing out the dimensions in the OP were wrong. :blush:
It seems most people designed everything in the correct dimensions and realized I made a mistake... only one person followed the dimensions in the OP. I have PMed him... sorry LikeHero, that is truly my bad!! Update the OP as well.
The correct dimensions are:
- The coin should be 39mm in diameter. (1.53543 inches)
- The back side of the coin must have a 1 inch diameter "donut" so that when the coin insert is placed on the coin and the hologram over it, there is no bulge.
- The inner part of the "donut" (where the coin insert will go) should be 12.7mm (0.5 inches)
- The outer part of the "donut" (where the hologram will go over) should be 25.4mm (1 inch)
- The hologram should be circular and 24.13mm (.95 inch) in diameter.