Just my luck... another burnt part, in a different unit. Unlike my other one there were no unusual symptoms beforehand. Same settings as the last unit.
Now I'm wondering if unplugging the affected miner from the bus would work. Might be tough to do, but it would let me use the other seven miners on that module without having to try and repair the broken one.
I suspect you might just be overclocking way too aggressively.Now I'm wondering if unplugging the affected miner from the bus would work. Might be tough to do, but it would let me use the other seven miners on that module without having to try and repair the broken one.
I have mine (Batch 1) overlcocked to 350 (constant) and I don't let it pass from 45C. The fans are set to 40%-100% with them running mostly at about 2000 to 2400 RPM~. Note: That is because I am using dust filters on the intake. So if I take them off the fan RPM would go even lower....but the unit become dirty on the inside and needs to be cleaned out.