OC not working first time miner is running? Using start.bat
I have OC set in my config
-cclock 1150
-cvddc 0850
-mclock 2000
-mvddc 850
-tt 57
The first time miner starts all gpus hashing 24.9 mh/s in eth.
If I close the miner window and open start.bat (which contains gpu force etc as mentioned on first page) the miner starts and gpus is hashing 30.x mh/s
Amd 18.2.3 drivers, compute mode enabled. (Trixx, wattman and amd settings etc is not installed).
I see the same behavior, though GPUz shows the frequencies that I intended to set, the miner hashes about 10% low. I stop and start again and it's back where it should be. This happens when using the older Blockchain drivers or the newest Adrenalin drivers. I thought I was losing my mind. Glad to see I'm not the only one. I've just learned to start twice after any re-boot.