Dev, solo is here you da man!  BUT I do have a couple of comments:

1. Your example at the top of your 2.7c release says -coin Vic and Akroma, but down in the list you don't list either of those.  Can you please amend or tell us a full and accurate list of coins that work under the -coin feature please.

2. I am using drivers on my AMD cards that run like a bat out of hell speed wise on low DAG coins but once I go back to high DAG coins it goes to sheet.  But I only mine low DAG coins so it does not matter to me.  But an issue I ran into is that I have all along used -minspeed in clay to reset my miner and re-apply my OCs when they fail and whatnot, but because the dev DAG is high by default, the -minRigSpeed calculates the devfree speeds into its feature, thus, unless I mine a -coin I cannot use -minRigSpeed because the DAG lowers my MHS during the devfree periods and calls up my -r function.  Even though my own mining is at a nice and high tweaked speed.  Clay does not calculate the DevFree periods into the -minspeed totals.

3. I am switching to solo Vic now so will try the -coin Vic to avoid the DAG switching high and impacting the -minRigSpeed mis-calulations for a work around for now. (more of a statement).  My last coin was not available under the -coin feature thus I could not use the -minRigSpeed feature and had numerous OC drops were I went periods un-optimized by a card or two.

4. Am I wrong or is the capitalization for the command lines are required.  If it is spelled out as -minRigSpeed in the instructions then you have to use -minRigSpeed as -minrigspeed wont be recognized.  Seems kind of trivial and I am sure causing more folks then just myself a headache.  unless I am wrong and this was just a 4AM sleep issue.