Do you know if there is any way to under-clock with the newer auto-tune firmware's?
People say no but when I change my browser adress on my autotune S9 from
http://192.168.1.102/cgi-bin/minerConfiguration.cgi to
http://192.168.1.102/cgi-bin/minerAdvanced.cgi I do get a secret page where I can change my frequency.
In case I want to underclock I would not worry too much and could try the 550 setting..
But If I would like to overclock to 675 frequency, and I don't like the heat and noise it creates, how do I change it back to the original autotune setting?
Anyone tried to overclock using this trick of the hidden advanced page , and how did it work out ? And how did you get back to the autotune mode?
Holy SCHNIKES! The secret frequency page URL is true! I just added "/cgi-bin/minerAdvanced.cgi " after my s9s IP address.
However you get a pop-up warning. Hence,
my question is... what does that "It will take about 3 hours on search frequency before mining! Are you sure?" I have never seen this before.
This is my 1st brand new factory sent Antminer - on any of the half-dozen used ones I have had, I understandably never had such issues, due to others having already over/underclocked.
Hardware Version 16.8.1.3
Kernel Version Linux 3.14.0-xilinx-gb190cb0-dirty #57 SMP PREEMPT Fri Dec 9 14:49:22 CST 2016
File System Version Sat Apr 29 20:01:20 EDT 2017
Please advise.