Got the same results as you did when i checked that. Im not so sure either. Ive tried to send multiple different values just to see if i could get the read data to change at all, but its just none. But then again, this SG Miner covers many of baikal`s miners, including earlier models - which i think this function is for.
Did go over the responses from ST chip, only data field;
Command BAIKAL_SET_ID
Returns:
Data(0) -> 1
Data(7) -> TEMP
Command BAIKAL_SEND_WORK
Returns:
Data(0) -> 220 (Frequency?)
Data(7) -> TEMP
Command BAIKAL_SET_OPTION
Returns:
Data(0) -> 220 (Frequency?)
Data(7) -> TEMP
Command BAIKAL_RESET
Returns:
Data(0) -> 3
Data(7) -> TEMP
Command BAIKAL_GET_INFO
Returns:
Data(1) -> 22 (Firmware ver?) Same return on Giant N so cant be..
Data(2) -> 113 (HW Ver?) Return 81 on Giant N, that may be firmware ver.
Data(3) -> 7 (BBG, whats that?) Return 0 on Giant N
Data(4) -> 220 (Frequency?) Return 210 on Giant N
Data(5) -> 64 (Total count of ASIC chips?) Return 32 on Giant N
Data(6) -> 64, 63 on two boards(Total count of Working ASIC chips?) Return 32 on Giant N
Data(7) -> 114 (Asic version?) returns 81 on Giant N.
Command GET_RESULT
Returns:
Data(7) -> TEMP