One of my miners hashes to a max for a like 4+ hours straight; then, everything fails. it goes to like infinitety hardware errors and 0 hashrate. What could be wrong and how could I fix this?
you're probably using pre-94 FW and one of your dies/VRMs is a bit flaky
with fw .95 and .96, they each give me a high hash rate whereas .96 is 20 gh/s more; however, after running at that level for four hours the hashrate went down to 1.86 mb/s. Then, after restarting it again, it would give out after about 30 minutes; then, it would do it in like 15 minutes. Is my Jupiter dying?I ran enable cores.bin. I don't know what could be wrong. Bertmod reports that most of the cores are on, only about 38 out of the 768 are off. Furthermore, the 5s hashrate shows it is getting a 525+ gh/s , but the avg hashrate is 1.86 mb/s. My hardware error rate is at about 7%
The 3rd asic slot chip reaches temperatures of around 67.5. Maybe there is a hardware shutdown temperature it it goes a little higher than that? I put a case fan on it and it runs cooler. I'll see if that was the problem
temp is too high in my opinion. did you check if "peel off sticker between heatsink and chip has been removed"? see link below.
EDIT: also with closed case the air flow is much better because of the two wings inside the case. I got lower temp of the second ASIC slots behind the first ASIC slots. but it need some time the miner adjust itself.